Z1000 swing arm for a 2007 Z750??

[Deleted]

Hi guys, ;D

Yeah You probably heard it all before on previous threads but will a Z1000 swing arm fit my 2007 Z750??

The cheap nasty steel one on mine is going rusty already and the bikes only done 1200 miles!!

If there is a previous thread about this can some one give me a link to it?

Thanks

[Deleted]

Lovely looking ride mate ;Dbut you need to tidy the arse end up

[kentsclan]

Don't think its been covered ??

but as both bikes share the same frame it should be a straight swop
the only thing that might need to be looked at is wheel spacers and rear brake mounting

[Deleted]

Hi Guys

the 07 Z1000 swinger will fit the 07 Z750 frame

but it all turns to shite when you see the 750 uses a thinner wheel spindle etc.

so the only easy way is to use the Z1000 rear wheel too.

but then it's too expensive.

maybe the ZX6C1 swinger will fit like it did on the old 750 ?.

Regards
Rick

[Deleted]

Rick,do you work for kawaski uk or somethin?,man your a wealth of information on zeds,i know who i'll be askin if i get stumped on anythin,you dont make slab yokes do ya? (after being sh*t on from a great height by TES PERFORMANCE!)lol ;D

[Deleted]

zedthoua1h said:

Rick,do you work for kawaski uk or somethin?,man your a wealth of information on zeds

Either that or he's gotta garage full of kawasaki bits that don't fit on his zed!

Albert Eistein? Nah!!! Ask Rick!!!! ;D ;D ;D

[Deleted]

Hi Guys

Jezz is closest.

I get the parts slides cds off a mate at local Kawasaki Dealer so i can look at bearing sizes etc when new stuff comes out that looks like it might fit my Z1000.

Used to work at Kawasaki Old Woking in mid 80's but not since ;D
(I have a Garage full of bits that do fit on my Z !) only need and engine & frame and it's another Z almost

Regards
Rick

[Deleted]

baldy said:

Lovely looking ride mate ;Dbut you need to tidy the arse end up

Yes I do! got a tail tidy just not got around to fitting it yet

[Deleted]

rickz1k said:

Hi Guys

the 07 Z1000 swinger will fit the 07 Z750 frame

but it all turns to shite when you see the 750 uses a thinner wheel spindle etc.

so the only easy way is to use the Z1000 rear wheel too.

but then it's too expensive.


maybe the ZX6C1 swinger will fit like it did on the old 750 ?.

Regards
Rick

If you are right Rick. It looks like it will become too expensive If I need a wheel as well

Its a pity as I think it is the only thing that lets the look of the 07 Z750 down