Post by Deleted on Apr 24, 2008 16:29:12 GMT
Hi , has anybody had any problems with exhaust servo on an 07/08 z1000? just notice'd mine is constantly moving side to side, i never notice'd it before
I know on start up the servo runs through its cycle then stops but on mine it runs through its cycle then starts to move about 5/10mm even if the ignition is on without the engine running.
I have changed the cans from stanard to scorpions.
Any idea if this is normal or should i be worried?
I know on start up the servo runs through its cycle then stops but on mine it runs through its cycle then starts to move about 5/10mm even if the ignition is on without the engine running.
I have changed the cans from stanard to scorpions.
Any idea if this is normal or should i be worried?