Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 1, 2008 18:19:31 GMT
Anyone know how to remove the rear body tail section to access indicator wiring Z1000 '05?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 2, 2008 10:36:22 GMT
Both seats off. There are two screws under the back seat that need removing. Under the tail unit are 6 ( might be 8) round plastic fittings. Haven't a clue what you call them. Push the centre of these in slightly and pull the whole fitting out. To refit you pull the centre section out a bit put the fitting in and then push the centre of it in.
Once the fittings are out its just a case of delicatly manipulating the plastic tail unit until you can get it off.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 2, 2008 10:57:03 GMT
Thanks Marco- will try today.
|
|
|
|
Post by andy on Mar 2, 2008 10:57:37 GMT
Both seats off. There are two screws under the back seat that need removing. Under the tail unit are 6 ( might be 8) round plastic fittings. Haven't a clue what you call them. Push the centre of these in slightly and pull the whole fitting out. To refit you pull the centre section out a bit put the fitting in and then push the centre of it in. Once the fittings are out its just a case of delicatly manipulating the plastic tail unit until you can get it off. Two little screws up the top under the back seat too, you'll see them when you remove the back seat/hump |
|
|
|
Post by andy on Mar 2, 2008 12:12:15 GMT
Have circled all the bits in red that need to be removed ;D   This pic below, yours will be different, cause I put shorter bolts in to keep the luggage hooks underneath as the standard ones were too long.  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 2, 2008 17:05:42 GMT
Thanks for the advice fellas. Got the tail off & dropped the undertray to fit rear indicators 'properly'. Sraightforward once you start looking & have a socket set. Took about 1 n1/2 hours. To drop the undertray you have to put the socket on the two bolts at the back of the tray FIRST, then your socket extension goes through the holes in the black plate. Took me 5 frustrating min. to figure this out & saved me 1/2 hour of turning 2mm at a time with an open ended spanner. DOW!!!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 13, 2008 13:10:03 GMT
is this pretty much the same procedure for a 2007??
|
|
|
|
Post by kentsclan on Mar 13, 2008 22:02:12 GMT
very similar
but under tray does not need to come off
remove both seats
the lh small silver plastic part the one close to injectors 1 x alan key
then the lh x larger black plastic side panel the one below rider seat 1 x alan key i think
then lh rear side pod to get to the wiring plugs x 2 alan key +
there is 2 x screws in the under tray that hold the side pod
all real easy
|
|
