Post by Deleted on Aug 24, 2007 18:12:20 GMT
I have just fitted my ZX10 rear shock.
Got all the bits I needed but was not sure about the lower linkage seals, they are alot different.
They were definatly part number 92049A as below and fitted fine but the z1000 seals seemed better....in some way
Any thoughts???
Besides that this was twenty minutes work and I never even took off the rear wheel.
Is a much neater/smaller shock than the Z1000, Fits perfect though.
This is the shock.
Not had a good blast but the short test seemed fine. looking forward to amorns morn ;D
Got all the bits I needed but was not sure about the lower linkage seals, they are alot different.
They were definatly part number 92049A as below and fitted fine but the z1000 seals seemed better....in some way
Any thoughts???
Besides that this was twenty minutes work and I never even took off the rear wheel.
Is a much neater/smaller shock than the Z1000, Fits perfect though.
This is the shock.
Not had a good blast but the short test seemed fine. looking forward to amorns morn ;D