Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 27, 2007 18:53:23 GMT
Just got my CRG levers. BUT................................before I fit them is it as simple as undoing the bolt and they come off and fit the crg's or is it not that simple.
Thanks Biker
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 27, 2007 19:05:18 GMT
You are indeed right , it is that simple, I would add a dab of grease aswell though.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 28, 2007 22:19:26 GMT
Hi, keep your eyes on the roller bearings on these levers, i would inspect the bearings at least once a month as i had one crack across the width of the casing, if it dose happen and you cant get a replacement bearing from your dealer, a new bearing is around £12, Doggie.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 17, 2007 17:53:43 GMT
Any photos of this swap?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 30, 2007 7:14:00 GMT
no sorry but it really is as easy as remove old and fit new BUT...................................dont forget to remove the bearing dowel on your original clutch lever and fit it intoi the CRG clutch lever. Its what the 10mm bolt goes through to hold the lever on. Biker
|
|