|
Post by masssa42 on Aug 13, 2021 20:17:18 GMT
please help with this problem does not want to start when it is hot around 100 degrees after I turned it off and my light flashes from the oil on the control panel and the oil is changed new and the oil level is as it should be mostly I figured out even to raise the front wheel to it hangs on the curb and only then lights up after about 1 minute, so it really confuses me.
|
|
|
Post by comfysofa on Aug 16, 2021 8:11:18 GMT
I would start with draining the oil and then making sure all the oilways (that you can easily get to) are not blocked.....also check the oil pump. Make sure it hasnt seized. If its full of oil and its overheating then oil is not getting pumped around the engine...thats my initial thought.
|
|
|
Post by masssa42 on Aug 17, 2021 17:39:58 GMT
thank you for the advice and to tell you there is logic and I realized that under the water pump my coolant is dripping so I will first get a set for repairing gaskets, seals, coolant and get to work and hope to solve the problem for by this ignition when the engine reaches a temperature of 100 degrees
|
|
|
Post by masssa42 on Aug 17, 2021 17:43:51 GMT
Here are the pictures in the attachment where you can see how the coolant accumulates and the cause is probably a worn out seal
|
|
|
Post by comfysofa on Aug 17, 2021 17:51:28 GMT
Ah - that was a good guess = well, thats your first port of call - i think the one pump does both oil and water ( but i might be wrong) - put some pics up as it comes apart - might help others if they have the same problem...
|
|
|
Post by masssa42 on Aug 19, 2021 11:05:30 GMT
I have a question if I have to drain the oil from the engine as well as the coolant when I go to repair the water pump when I go to remove the water pump thank you
|
|
|
Post by masssa42 on Aug 20, 2021 11:12:23 GMT
to correct myself do I have to drain the oil from the engine as well as the coolant when I need to remove the water pump
|
|